Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO63
6.12m W x 3.11m D x 2.60m H
Model: ADGAZEBO63
4/12/23
1.00
10
5.
Refit the flashing, and fasten using pop rivets
FAST102
at the locations shown.
Only at the low side, on top, use teks with
neoprene washers
FAST101.
HIGH SIDE UNDERSIDE VIEW
FRONT TOP VIEW
6.
Repeat these steps for
the other end flashing. Just
remember to make the
mirrored version.
FRONT & REAR FLASHING
LOW SIDE UNDERSIDE
VIEW
1.
Starting at the front end of the structure,
take one
TR37
flashing and place over the front
flashing and roof panels as shown.
2.
Take the second TR37 flashing and place
alongside, butted against the first & trim so it
finishes at the rear flashing.
3.
Fasten with pop rivets
FAST102
along the
underside are shown.
Fasten with tek screws with neoprene washers
FAST101
along the top.
To increase weather protection do the following.
A.
Turn up pans of sheet 15 degrees using “Sheet
Metal Locking Pliers”
B.
Installing foam gaskets
RWG28
within 90mm
of the edge.
Some trimming may be required to fit at ends.
Apply silicone to the face that sits in the pan.
UNDERSIDE VIEW
TR37
#1
TR37
#2
FRONT EDGE
FRONT FLASHING
