Absco Industries
Assembly Instruction Manual
ABSCO WORKSHOP SHED
MODEL: 60303WK
20’W x 10’D x 7’H
Model: 60303WK-PTX
2/03/2023
11
Australian Made
Guide on Joining a Spliced Ridge Beam
Follow these three steps to assemble a ridge beam.
Step 1.
Place two ridge beams as
shown and push them together.
Slide the cap of one under the
other.
NOTE.
There is a 2” overlap of the ridge
caps when the beams are in posi-
tion.
Step 2.
Use the ZARSP to connect at
the centre of the two ridge
beams. Be sure it is pushed in
fully.
Step 3.
Turn over the ridge beam.
Measure 9.84” from the middle
along the centre of one ridge
beam, mark spacings of 2”. Fasten
with a Tek screw at each marking.
Repeat to the other side of the
ridge beam assembly.
TIP: Predrilling each hole with
the 1/8” drill bit makes it easier to
fasten.
2”
8.86”
ZARSP
Finished Spliced Ridge Beam
Finished
Joined Ridge Beams
Hex Hd Self-drilling tek screw
with neoprene washer
ZARSP
Push
Hex Driver Bit
If present, remove plastic coating from top side
of ridge beam capping before assembly.
