Absco Industries
Assembly Instruction Manual
Model: CYC15
02/03/2021
1.0
16
N3/C1 FRAME KIT
FOR 1.5m WIDE TO
1.5m DEEP MODELS
ROOF BRACING
1. Align the roof framing along the midpoint of
the roof, running perpendicular to the roof sheet
corrugations. This may require two people.
2. Using a marker trace along one edge of the
channel onto the roof sheet as shown.
Next measure 20mm in from this line and mark
again, this will the centreline of the bracing.
3. Proceed to drill a hole in every 2nd flat section
of the roof sheet.
4. While one person holds the roof brace in
position use hex head teks screws with neoprene
washers to fix the framing from the outside of the
shed.
IMPORTANT: Do not sit, stand or walk on the roof
or apply unnecessary pressure of the sheeting
during this step.
5. Place a BKT17 to either end of the roof brace
using 8 tek screws as shown to the right.
The roof lip may need to be removed in order
to fit the four tek screws from the outside of the
shed.
Two multipurpose
brackets, BKT17, are
used per roof brace.
HEX HD
TEK SCREW W/ NEO
WASHER 10-16x16mm
