Specification #8810502
Original 5/14/98
ABS<Comtrak
1700-1702
Installation & Start-up Procedure
4
Revision, 1/5/99
limits for a minimum of for
30
minutes. This violation rearms itself if an individual moves
back inside these limits after being out for 30 minutes.
•
Cuff violation - Occurs when a client forcibly removes or cuts the bracelet from the
transmitter. This violation will not page again until the bracelet has been replaced and the cuff
has been rearmed (minimum of 10 seconds) with the rearming tool.
Cautions
•
After rearming is complete the client must stay within the proximity limits for 5 minutes.
Premature movement outside these limits may prevent a cuff violation from being
detected.
•
Metal obstructions, in the line of sight between the cuff and the PTU, such as metal
filing cabinets, walls or refrigerators can result in false proximity violations.
Wireless Cuff Training/Activation: Model 1700-1705
•
Plug in Customer Cuff Tester (#1021835).
To do this unzip the unit and find the white
GPS antenna housing on the tip side of the unit and place that end farthest away from you.
Then pull the bag down and plug the test unit into the jack on the end of the unit closest to
you.
Note: This test unit is helpful, but not absolutely necessary to train/activate the cuff
.
•
Locate the wireless receiver.
If the unit is not sealed, unzip it and locate the white GPS
antenna housing on the top side of the unit. Facing the housing to your right, the wireless
receiver is at the bottom left corner of the unit. If the unit is sealed, face the unit Identification
tag away from you. The wireless receiver will then be located in the bottom left hand corner
of the unit as seen in the following picture
White GPS
antenna housing
Customer Cuff
Tester (#1021835)
Phone plug jack
