Installation instructions for the OPEN SURF System and OPEN SURF System 2 above-water automatic slatted safety cover - 16/22
16
4.3 Solar cabled model
5. Assembling the slats
Please refer to the "Slat cover" instructions.
Gris
Bleu
M22K10
+
-
+
+
-
-
+
-
Rose
Vert
+
-
Rouge
Noir
Bleu
Marron
M=
I
0
II
+
-
+
-
FORCAGE
Violet
Noir
Schéma électrique Surf modèle filaire solaire
Noir/blanc
Noir
Marron
Bleu
Rouge
Noir
Brown
Blue
Blue
Black
Black
Black
Red
Black/white
M=
Green
Grey
Violet
Pink
FORCING
M22 K10
Blue
Brown
Black
Red
OPEN SURF cabled solar model electric
diagram
SURF System 1: Connect the spiral wire to the screw
terminal inside the previously installed solar stand.
SURF System 2: The solar panel is assembled on the
SURF frame and its wires are already connected to the
regulator.
Remove the cover (see § 3.6) and connect the violet
wire to the batteries.
Fig. 31
Test the tube's rotation in both directions. The slats
should roll by passing over the roller shaft. If the
movement does not match to the correct direction,
invert the blue and brown wires.
Let the tube turn in the unrolling direction until the
motor stops (unrolling limit switch stop).
Finish the adjustment of the limit switches once the
cover's slats have been assembled.