15/22 - Installation instructions for the OPEN SURF System and OPEN SURF System 2 above-water automatic slatted safety cover
15
Gris
Bleu
M22K10
+
-
+
+
-
-
+
-
Rose
Vert
+
-
Rouge
Noir
Bleu
Marron
M=
I
0
II
+
-
+
-
FORCAGE
Violet
Noir
Schéma électrique Surf modèle autonome et
autonome solaire
Noir/blanc
Noir
R
ou
ge
Bl
an
c
1
3
1
3
Marron
Bleu
1
3
Rouge
Noir
Marron
Bleu
OU
Black
Black/white
Re
d
Whit
e
Blue
Brown
Black
Grey
Black
M=
M22K10
Brown
Blue
Green
Blue
Violet
Pink
FORCING
Blue
Brown
Noir
Red
Red
OR
4.2.3 Fig. 34 et 35
To recharge the batteries, leave the connector
permanently connected to the post when the OPEN
SURF is in the rear position.
Fig. 34
Fig. 35
4.2.1 For the stand-alone model, the transformer box is to
be fitted in the technical room
Fig. 32
Connect the 230 V power supply cable in the electric
box to the terminal marked "T" for the earth, "P" for
the phase and "N" for the neutral.
Connect the two power wires of the connecting
cable to the terminals marked "+" and "-" in the box.
4.2.2 Remove the cover (see § 3.6) and connect the violet
wire to the batteries.
Connect the power wires to the screw terminal
in the stand and connect the violet wire to the
batteries which are in the motor stand.
Fig. 33
Test the tube's rotation in both directions. The
slats should roll by passing over the roller shaft.
If the movement does not match to the correct
direction, invert the blue and brown wires
Let the tube turn in the unrolling direction until the
motor stops (unrolling limit switch stop).
Finish the adjustment of the limit switches once the
cover's slats have been assembled.
OPEN SURF stand-alone and solar stand-alone
model electric diagram
4.2 Stand-alone and stand-alone solar models
