The packing list is for reference only. If there is any change, the actual item shall prevail.
This manual may contain technical inaccuracies or misprints. The contents of this manual will be
updated from time to time without prior notice. The updated contents will be included in the new
version of this manual. We are always ready to improve or update the products or procedures
described in this manual.
1.
2.
REMARKS:
ABRAMS INSTALLATION AND CONFIGURATION MANUAL V1.4
WWW.ABRAMSMFG.COM | [email protected]
8
844.9.ABRAMS
WWW.ABRAMSMFG.COM
INSTALLATION AND CONFIGURATION MANUAL
FOR
TORNADO 3
LOW FREQUENCY SIREN SYSTEM
Make sure that the amplifier and speaker matched.
Be aware that the ground wire must be connected to the negative
If anything is blocked in front of the speaker port, the sound will be reduced, make sure the front
of the speaker is empty or free of any obstacles;
Do not install the speaker where it may interfere with the operation of the airbag sensor;
Two loudspeakers should be connected in parallel when installation.
As the low frequency is an efficient infrasound, it cannot be activated continuously.
Do not connect the alarm devices to the car battery until all parts are installed and no short
circuit.
When approaching or connecting the battery, protective measures should be taken to avoid
sparks, which may cause damage to the vehicle or personal injury
When moving the low-frequency alarm system, all power should be disconnected, and
hot- plugging is not allowed.
Amplifier and speakers must match to work properly.
