page 11
page 6
RECHARGING NI-MH BATTERY
1. To maximize the life of the battery, power is automatically shut
off after 10 minutes of non-use or user-defined interval.
Automatic shut off is bypassed during USB output or when
used with the AC adapter/charger.
2. Battery icon will flash when the tester needs to be
recharged.
3. Push
to turn off power. Only use the IMADA AC adapter/
charger provided, AD120 for 115VAC, AD230 for 230VAC. Plug
into the correct AC output. It takes 10 hours to charge fully.
4. When the tester is turned off, make sure the AC adapter/charger
is disconnected to avoid overcharging.
OPTIONAL CABLES
10' Analog cable
CB-104
10' RS-232C cable, 9 pin female
CB-204
10' Digimatic Cable
CB-304
If High and Low setpoints have been programmed (see page 5),
for example, 5 lbf-in is set as Low and 10 lbf-in as High, the
ORANGE LED light for measurements less than 5 lbf-in (Low set-
point). GREEN lights between 5–10 lbf-in and RED lights over 10
lbf-in (High setpoint). Setpoint output is available through the
Communications port (see page 7).
After measuring, press the
button to transmit data to:
RS-232 models:
RS-232C or Digimatic devices
Storing Data into Memory
During measurement whether Peak or Real Time, press
to store
and display up to 1,000 torque values into memory. (If no data is
stored
– – – – –
is displayed then flashing CF9 with solid End).
Tare
Clamp container firmly to the sample table (C) by tightening the
clamp handle (A). If necessary, press
to tare before the test.
Pressing
also clears the peak reading.
Grip the sample lid and rotate to open (CCW) or close (CW). The
display will indicate the torque value with CCW
or CW
icons.
(A) CLAMP HANDLE
(C) SAMPLE TABLE
CONTAINER
Clamp container, then twist
sample lid by hand to
measure torque.
