Copyright
2006, Delmhorst Instrument Co.
Page 12 of 32
laptop via Infrared connection. Jobs may be defined only when using the meter in pin
mode or RH-T mode. Scanned readings cannot be part of a job.
TO CREATE OR MODIFY A JOB IN PIN MODE:
1.
From the Enhanced Main Menu,
highlight
PIN MODE.
2.
Use the
keys to highlight
JOB. Press
SELECT
to enter the job sub
menu.
3.
Use the
key to change the job number
. Press the
key and highlight
DONE
. Press
SELECT
to save that job number.
If it is a new job, the “Create Job”
screen will appear as follows:
At the “Create Job” screen, you may
select the material being tested, specify
the temperature at which measurements will be taken, and select an alarm value,
if desired. All parameters are alterable while taking readings in the new job,
except for the species.
If the job was previously defined and used
, you will be asked if you want to
“Append Data?”
Use the
keys to answer “YES” or “NO.”
If YES is selected, the meter
will retrieve the selected job’s settings (during this time a “PROCESSING…”
message appears) and then switch back to the Pin Mode screen with the
restored settings.
If NO is selected
, the meter returns to the Job sub menu.