EN
9
Using your Walkslim 470
STARTING THE WALKSLIM 470 USING THE REMOTE CONTROL MODE
• This mode will use your Remote Control to adjust your speed
• Plug in the power, turn on the red switch. You will hear a beep and the screen will light
up.
• In the standby mode, attach the safety magnet on the red safety magnet holder
located in the middle of the handrail , press the power button on the remote control,
the treadmill will start at the lowest speed.
• Speed increase / decrease: press the + button on the remote control while you are
walking to increase the speed at 0.1km/second. To decrease the speed, press the -
on the remote control. The treadmill will decrease speed at 0.1km/second.
• Stopping the Treadmill: Press the start/stop button on the remote control when you
have finished your walking session. The Treadmill will stop slowly and enter standby
mode. Ensure when the Walkslim 470 comes to a stop that you hold onto the handrail
for support and stability.
EMERGENCY STOP
• The Walkslim 470 has an emergency stop (red safety magnet).
• When in operation, if you feel the need to stop the treadmill quickly, simply pull the
safety magnet out of the safety magnet holder. The treadmill will stop quickly to
ensure your safety.
• After pulling the safety magnet out, to start the Treadmill again, place the red safety
magnet in the safety magnet holder on the handrail. The Walkslim 470 will enter
standby mode.
• Remote control as shown
Power button
Speed Increase
Speed Decrease
