26
(
6) Your start-up operation of the UPS is completely now as illustrated as
drawing E. Make sure the UPS is plugged onto the wall receptacle for
charging at least 4 hours and the batteries of the UPS are fully charged
4.4.2.2 Start-up in Battery Mode (Cold Start)
(1) Make sure the UPS has already been installed with batteries.
(2) Press the UPS On switch to awake the UPS for approx. 3 seconds, and
then the buzzer sounds twice. The LCD display will illustrate from
Drawing A to drawing G.
G
(3) Press the UPS On switch of the UPS again for approx. 3 seconds till the
LCD display illustrates from drawing G to drawing H, then the UPS will be
in self-test Mode. The UPS may offer energy to the output in a minute,
and the LCD display illustrates as drawing I. In case of failure in pushing
the UPS On Switch in 10 seconds, the UPS will automatically turn off.
H
I
27
4.4.2.3 Check Measured Values & Figures detected by UPS
(1) If you would like to check the measured values & messages, please use
scroll up
and scroll down
key pads. When you use scroll down
key pad, the LCD display will illustrate in sequence from Drawing E(Input
Voltage)
Æ
Drawing J(Input Frequency)
Æ
Drawing K(UPS Output Voltage)
Æ
Drawing L(UPS Output Frequency)
Æ
Drawing M(UPS Output Load
percentage)
Æ
Drawing N(UPS Battery Voltage)
Æ
Drawing O(UPS inner
temperature
J
K
L
M