User manual Version 1.5
SW5001 Wireless Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 5 -
3.2. IP
Assignment
3.2.1. Configure IP by SerialManager Utility
Use
SerialManager
configuration utility that comes with product CD or diskette to configure the network
parameters. For more details, please refer to
Appendix B1
.
Find new device and IP assignment
Use
SerialManager Utility
for finding new device IP address, get device’s current IP from table
list.
Re-assigned IP, network mask and gateway if need with
SerialManager Utility
.
User can configure User ID, Password and Host Name with
SerialManager Utility
.
Fig 2. IP settings for SerialManager Utility tool
Note: All settings were NOT changed if user ID or password was incorrect.
If there is more than one device using the same IP address in same Subnet. User has to correct mapping
between MAC address & IP address by ARP commands.
ARP
commands
ARP (address resolution protocol) commands can be used to assign a static IP address on SW5001 using
its hardware MAC (media access control) address. The MAC address"0060E9-xxxxxx" is printed on the rear
side of SW5001. The following figure shows how to use ARP command on MS-DOS command prompt
window.
Example
: Set IP
10.0.50.101
to
MAC address
00-60-E9-00-79-F8
.
Fig 3. Map IP address to MAC address by ARP Command
