Abit BE6-II, User Manual

Page: 47 / 122

Introduction of the BIOS 3-17
User’s Manual
Delay ). If this item is set to Disabled, the BIOS will use the default setting. The default
setting is Enabled .
Typematic Rate (Chars/Sec):
When you press a key continuously, the keyboard will repeat the keystroke according to the
rate you have set (Unit: characters/second
）
. Eight options are available: 6
-
8
-
10
-
12
-
15
-
20
-
24
-
30
-
Back to 6. The default setting is 30 .
Typematic Delay (Msec):
When you press a key continuously, if you exceed the delay you have set here, the keyboard
will automatically repeat the keystroke according to a certain rate (Unit: milliseconds). Four
options are available: 250
-
500
-
750
-
1000
-
Back to 250. The default setting is 250 .
Security Option:
This option can be set to System or Setup. The default setting is Setup . After you have
created a password through PASSWORD SETTING, this option will deny access to your
system (System) or modification of computer setup (BIOS Setup) by unauthorized users.
➤
SYSTEM: When you choose System, a password is required each time the computer
boots up. If the correct password is not given, the system will not start.
➤
SETUP: When you choose Setup, a password is required only when accessing the
BIOS Setup.
If you have not set a password in the PASSWORD SETTING option, this option is not
available.
To disable security, select Set Supervisor Password at main menu and then you will be asked
to enter password. Do not type anything and just press the Enter key and it will disable
security. Once security is disabled, the system will boot and you can enter the BIOS setup
menu freely
Notice
Don’t forget your password. If you forget the password, you will have to open the
computer case and clear all information in the CMOS before you can start up the
system. But by doing this, you will have to reset all previously set options.