Installation Method:
1. Drill 4 holes in the wall.
2. Screw the two fixing screws off the cover with the hexagonal
wrench and remove the panel. Detach sensor connecting wire.
3. Using the screws, fix the machine on the wall & connect it to
electric power. (Please Note: We recommend the installation to be
done by a professional electrician only).
4. Put the cover on the machine and cover it using the hexagon
wrench.
5. Plug the hand dryer in power.
Test Operation:
After installation, please test the hand dryer operation according to
the steps below:
1. The hand dryer should be in standby mode after the power
has been switched on.
2. The hand dryer should automatically stop after 60 seconds
of work.
1. If the hand dryer sensor is not working or turning on automatically,
please adjust the sensor distance trimmer. The trimmer is indicated in
Picture 1.
2. The closer you place your hands to the hand dryer, the faster they
dry.
3. Be careful of the surface heating when in use continuously.
Tips:
1. After washing hands, place hands under air outlet around 10 cm
away. The hand dryer will be automatically activated using the
automatic sensor. Please retreat the hands when hands are dried, and
it will stop working in 2 seconds.
2. After 60 seconds of continuous usage, the hand dryer will stop
automatically.
3. Do not dry any clothes or handkerchiefs, etc.
4. Do not pull the electric cord abruptly to avoid any short circuits.
5. Do not use the hand dryer for extremely long hours. The wind
outlet might get extremely hot and damage the sensor.
Usage:
