Abiomed Impella Connect, User Manual

Page: 10 / 72

8 Instructions for Use
INDICATORS AND OPERATING MODES
Connection Indicator
Mode
Blue
Cloud
Indicator (A)
Amber
Flight Mode
Indicator (B) Notes
No Status Off Off No Power.
Connected On Off Connected to Wi-Fi network.
Maintenance Flashing Off Device in Maintenance Mode.
Initialization in Progress Flashing Flashing Device Powering up.
No Network Configured
1 Blink
5 sec off
Off No Wi-Fi networks are configured.
Carrier Connecting
2 Blinks
5 sec off
Off
Configured Wi-Fi is out of range OR the device
has failed to authenticate with the network.
IP Configuration
3 Blinks
5 sec off
Off
No IP from DHCP. The device has authenticated
with the network, but no IP address has been
assigned.
1
RLFS Connecting
4 Blinks
5 sec off
Off RLFS not connecting. 2
RLR Connecting
5 Blinks
5 sec off
Off RLR not connecting. 2
RLV Connecting
6 Blinks
5 sec off
Off RLV not connecting.
2
1. Confirm the DHCP setting configured in the maintenance mode is correct.
2. Confirm firewall settings and ensure that deep packet inspection is turned off and MAC addresses are whitelisted, and proxy servers are bypassed.
The Impella Connect will automatically connect to the cloud when in range of an approved* Wi-Fi network
In locations where Wi-Fi is not available, the Impella Connect can be connected to the cloud via the Ethernet port
located on the Impella Connect.
To configure a Wi-Fi network, a user must enter Maintenance Mode. To do so, firmly press the Flight Mode button
until the Connection Indicator light flashes amber and continue holding for 15 seconds before release. Once
released, after a few seconds, the Connection Indicator light will turn to a continuous flashing blue indicating the
Impella Connect is now in Maintenance Mode.
Note: The Connection Indicator for older versions of the Impella
Connect module may not flash amber when pressed firmly.
To exit Maintenance Mode, press the Flight Mode button for >1 second and release.
* Approved network means SSID and password/credentials have been configured in the Impella Connect by an
authorized IT administrator.