Seat Swivel Adjustment:
Pull the lever (T) upwards to disengage and rotate seat (P) to required angle, Let go of the lever
(T) to lock the seat into its required position.
Seat Back Angle Adjustment:
Pull the lever (U) upwards to adjust
Pull the lever (U) upwards to adjust
backrest’s angle, then release the
lever when adjusted to required
position, then release the lever when
adjusted to required position.
CAUTION: For safety reasons the backrest’s position must remain vertical before driving.
Seat Height Adjustment:
1. Remove seat (P) and rear shroud (Z).
2. Remove screw, nut and washer from seat post (V).
3. Adjust seat post (V) to desired height, and attached tightly with screw, nut and washers.
4. Then assemble the rear shroud (Z), seat (P) back to its original position.
Seat Electrical Lifter (Optional):
1. Press seat lifter button lightly (W) to raise the seat. Press lightly, to lower the seat.
CAUTION:
• Do not operate this function on a slope, or in motion or under unstable condition.
• The main purpose of this function is to assist you to reach certain height.
• Seat’s position must remain at the lowest before driving.
• Do not set N-D lever at N, before setting the seat at lowest position.
• Please keep the center of gravity of the scooter in the middle, to prevent the scooter
tipping over.
N-D Lever Adjustment:
When scooter has stopped or is
experiencing problems, press the
unlocking knob on the N-D lever (X).
Push the N-D lever forwards this
will allow you to push the scooter
by hand.
CAUTION: Freewheel operation is only recommended on flat surfaces, never on slopes.
Never leave your scooter on a slope with its engine switched off. Always switch the engine
on immediately after pushing the scooter.
CAUTION: The scooter won’t operate if it is
set at (N) position, to restore to it’s normal status,
you must switch the power off and adjust to (D)
position, then switch the power on.
07
U
T
P
V
W
P
D
N
X
V
