Abilia Progress Micro USB, Manual, Page: 23 / 45

23
Alarm Function with a control switch
If an external control switch is held pressed for approximately 4.5 seconds an
alarm will be given. When activating the alarm function an alarm symbol will be
shown on the screen with a sound signal. The image and sound cannot be
changed. The alarm function can be caused to operate in two different ways:
1. Via a relay output (default). Note! Does not work with Progress Star or
Progress Micro.
2. Progress sends a freely chosen GewaLink channel. The channel is chosen
when the function is chosen.
Choose between relay output and GewaLink channel by the following
procedure:
Settings  System  Alarm function  Choose between relay output and GewaLink
channel
Alarm function on any button
The alarm function can be placed on any button in Progress PC. An image
and a sound signal are chosen at the same time as the function is chosen.
Another image can be used if the alarm symbol is not satisfactory – see the
section
Adding Images on page 24. The alarm function always activates the
relay output without delay. Note! Progress Star and Progress Micro do not have
any support for this function. If the alarm is to send an IR channel it can be
changed afterwards, see the section
Inserting GewaLink channels , page 20.
Set up the alarm function by the following procedure:
Settings  Pages/buttons  Select page  Select the page on which the alarm
function is to be placed  Select this page  Edit button  Select the button on
which the alarm function is to be placed  Function  System function 
Alarm relay output  