Abicor Binzel PP 240D, Operating Instructions Manual

Page: 24 / 68

EN - 8
4 Putting into operation PP
1 Lay down the cable assembly (9) straight and unscrew nut (6) from central
connector (4) .
2 Slide the liner (8) through the wire conduit (3) until a noticeable resistance
is felt in the inlet nipple (2) .
3 Determine excess length x and pull out the liner (8) again.
4 Shorten the liner (8) by the dimension x.
5 Debur the cutting point and sharpen the spiral beginning to an angle
of 40°.
6 Insert the liner cut to length (8) into the wire conduit (3) .
7 Screw down nut (6) and secure with multiple wrench (5) .
4.1.2 Liner (plastic)
For use with aluminium, copper, nickel and stainless steels
1 Lay down the cable assembly straight and unscrew nut from central
connector
(2) .
2 Sharpen the beginning of the PA liner (8) to approx. 40° using the
ABICOR BINZEL sharpener (9) .
3 Slide PA liner (8) through the wire conduit (1) into the inlet nipple (10) until
a noticeable resistance is felt.
4 Slide clamp nipple (7) , O-ring (6) and nut (3) on the PA liner (8) and
tighten the nut (3) under tension.
5 Mark a PA liner (8) that is too long in front of the wire feed rolls (4) (wire
feeder).
6 Cut the PA liner (8) at the mark directly in front of the wire feed rolls using
the ABICOR BINZEL cutter (5) .
7 Sharpen the cutting point.
1 Wire conduit
2 Central connector
3 Nut
4 Wire feed rolls
5 ABICOR BINZEL Cutter
6 O-ring
7 Clamp nipple
8 Liner (plastic)
9 ABICOR BINZEL
Sharpener
10 Inlet nipple
Fig. 3 Shortening the PA liner
1 2
4
3
5 6 7 8
9
10
40°