Abicor Binzel iCAT mini, Operating Instructions Manual

Page: 56 / 148

EN - 22 BAL.0361.0 • 2021-02-25
6 Commissioning iCAT mini
6.5.2 Mounting the welding torch neck ABIROB
®
G (iCAT mini with wire brake)
1 Equip the welding torch neck ABIROB
®
G (2) with tip adaptor, contact tip, and gas nozzle.
2 Insert the neckliner (3) in the torch neck until it stops.
3 Loosen the cylinder head screw (8) .
4 Mount the welding torch neck ABIROB
®
G (2) in the welding torch interface (4) . The
welding torch must be inserted all the way into the welding torch interface (4) .
5 Tighten the cylinder head screw (SW4) with a max. tightening torque of M=6 Nm to fix the
welding torch.
NOTICE
• The torch neck for the wire brake must be equipped with the neckliner intended for this
purpose. The neckliner used depends on the wire diameter and the welding torch
geometry.
• Consult the documentation for the welding components.
1 Protective cap
2 ABIROB
®
G torch neck
3 Neckliner
4 Welding torch/cable
assembly interface
5 Wire brake
6 iCAT mini
7 Bellows
8 Cylinder head screw M5 × 16
Fig. 11 Mounting the welding torch neck ABIROB
®
G ( iCAT mini with wire brake)
6
7
1
2
3
4
8
5