BRS-LC
6 Inbetriebnahme
BAL.0030 • 2019-01-18
DE - 15
6.8 Einsprüheinheit (Option)
Nach dem Reinigungsvorgang wird der Brenner aus der Spannposition
zum Einsprühen mit der Gasdüse
über den
Injektor
gefahren.
In dieser Stellung betätigt die Gasdüse
den Rollenhebel
umgesteuert wird. Die
Druckluft wird nun nicht mehr dem Hubzylinder zugeführt, sondern dem Injektor
.
Abb. 12 Pneumatikplan auf Seite DE-18
Mit dem erneuten Setzen des Steuersignals Hub = 1 wird nun der Einsprühvorgang aktiviert. Die durch den Injektor
strömende Luft erzeugt im Saugschlauch
ein Vakuum. Dadurch wird das Antispritzerschutzmittel aus dem
Antihaftmittelbehälter
angesaugt und der durchströmenden Luft beigemengt.
Abb. 11 Ablaufdiagramm auf Seite DE-17
6.9 Elektroanschluss herstellen
1
Lösen Sie die seitlichen Befestigungsschrauben und nehmen Sie die Abdeckhaube ab.
2
Anschlusskabel durch PG 9-Verschraubung dem Klemmenblock zuführen.
3
Klemmenbelegung: Betriebspannung 24 VDC auf X1.7, GND auf X1.5.
4
Steuersignal-Eingang für „Lift“ (Hubbewegung) auf X1.10.
5
Steuersignal-Ausgang für „Ready“ (Hub ist unten, Spannzylinder offen) auf X1.12
1
Spannposition P2
2
Gasdüse
3
Rollenhebel
4
Injektor
5
Saugschlauch
6
Antihaftmittelbehälter
7
Wegeventil
Abb. 9
Funktionsablauf Einsprühen
2
1
3
4
5
6
7
HINWEIS
• Die Brennerreinigungsstation muss während der Einrichtarbeiten druck- und spannungsfrei sein!
• Der Gasdüsendurchmesser muss mit dem des Prismas übereinstimmen.
• Die Abstandshülse muss mit der Gasdüsennennweite übereinstimmen.
• Der Fräser muss exakt auf den Brennertyp abgestimmt sein.