ABICAR ADVANCED
7 Operation
EN
-
19
► Consult the documentation for the welding components.
7.1 Functional check
► Switch the device on using the on/off switch.
7.2 Welding process
Starting the welding process
1
Ensure that the device is protected against falling.
2
Ensure that the welding torch neck is securely attached.
3
To start up the magnet, set the magnet lever to “ON”.
4
Adjust the speed on the speed controller.
5
Set the weld start signal switch to “I”.
6
Set the travel direction switch to the desired direction.
If the arc ignition switch is in position “I”, then the welding torch will start to weld immediately after the travel
direction switch is actuated.
Stopping the welding process
1
Set the travel direction switch to “O”.
2
Set the weld start signal switch to “O”.
3
Switch on/off the device.
NOTICE
Material damage due to weather conditions
Weather conditions can cause irreparable damage to the device.
► Do not use the device in frost or rain.
Correct indicator after switching on. The
current speed will be displayed.
Indicator does not light up completely
► Consult your specialist dealer or the
manufacturer.
Indicator setting cm/min
6.1 Changing the speed indicators on
page DE
Indicator inch/min
6.1 Changing the speed indicators on
page DE
Travel direction switch not set to “O” when
the power supply is switched on
► Set the travel direction switch to “O” and
restart. Consult your specialist dealer or
the manufacturer if necessary.
Motor overloading. Device stops.
Possible reasons:
Use of unapproved electric cable.
► Use the electric cable as specified in the
technical data.
Obstacles blocking the welding car.
► Remove obstacles.
Consult your specialist dealer or the
manufacturer if necessary.
WARNING
Risk of burns from hot surface
Welding torches become very hot during welding. They could cause major burns.
► Allow welding torches to cool down after welding.
► Wear the correct protective gloves.
