Please read and understand setup guide prior to installing the Electric Actuator!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐ www.abiattachments.com
Attaching the Control Box and Wiring Harness to the Rascal –
The control box needs to be attached to the Rascal with the support plate facing the tow vehicle.
This will help to protect the control box from any debris that is flung back from the tires of the tow
vehicle. The control box will need to be secured to the frame of the Rascal where the support arms
connect to the tongue assembly.
1. With the support plate of the control box facing the tow vehicle line up the predrilled holes at the
bottom of the support plate so that the u bolt can be inserted into each hole.
2. Insert the u bolt into the two predrilled holes on the bottom of the support plate
3. Next, place the flat bracket into the ends of the u bolts under the bottom of the frame, and loosely
secure it using the two provided
½
” nuts.
4. Before fully securing the control box to the frame of the Rascal ensure that the control box is pushed up
as close as it can to where the support arms are welded to the tongue assembly. Make sure that all the
wires coming out of the control box are not resting between the control box and the frame of the Rascal,
and tighten the
½
” bolts fully.
5. Now connect the remaining double sided 4 prong extension cable to the 4 prong connector coming
from the control box.
6. Optionally, loosely secure the double sided 4 prong extension cable to the frame of the rascal by using
wire ties, or other means.
7. With the double sided 4 prong wiring harness loosely secured, make sure that both ends of the cable
will properly reach the control box and the end of the wiring harness on the tow vehicle with some slack
on both sides. Lastly, secure the cable firmly to the frame of the Rascal.
**When securing the wiring harness to the frame of the Rascal allow some slack on control box side and
on the ATV side. This will prevent the wiring harness from pulling tight during operation and use, which
may cause damage to the wiring harness.
