Please read and understand setup guide prior to installing the Electric Actuator!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐ www.abiattachments.com
3. Next, using the shortest of the three remaining screws, to attach the flat bracket to the center hole of the
L shaped bracket. Secure the bracket using one of the silver nuts and a 5/16” wrench along with a Phillips
head screw driver.
Figure 5
Once a spot has been determined for securing the rocker switch, the remainder of the switch can be
assembled. Ensure that the final location allows for some slack in the wiring harness to prevent
damage to the wiring harness during use.
4. Using one of the remaining screws loosely secure the remaining curved brackets to the flat bracket. The
curved brackets can be placed side by side, or the can be secured with the flat bracket between them. Use
a 5/16” wrench along with a Phillips head screwdriver, to secure the nut to the screw.
Figure 6
5. Slip the open end of the curved brackets over the bar where the rocker switch will be located. Secure
the fully assembled rocker switch with the final screw, and ensure that all the nuts are secured firmly.
Figure 7
The rocker switch can be slid side to side as desired by loosening the screw between the curved
brackets and the flat bracket.
