Please read fully and understand before operating the Infield PRO
ABI(
Absolute Innovations, Inc.
)
4
of
8
Tools needed for assembly:
¾” Combination Wrench
¾” Socket with Wrench
Metal Snips
Removing the Infield PRO from the Pallet-
1)
Remove all boxes containing additional parts from the shipping pallet and place them off to the
side.
2)
Locate the hitch bar for the PRO. It is shipped removed from the PRO and will be wrapped in
packing material.
3)
Secure the hitch bar to the PRO by inserting it into the receiver
slot using the two provided bolts to secure hitch bar to the PRO
frame. The hardware used to secure the hitch bar to the PRO will
feel cross threaded when you tighten it. The nut is designed to
grip the bolt to prevent it from loosening while the PRO is in use.
Refer to Figure 1 for reference.
4)
Remove all banding that is holding the PRO to the shipping pallet.
A pair of metal snips will be needed to remove the banding from around the PRO frame. Be
careful removing the banding as it may spring back once cut, and the banding may have sharp
edges once cut.
5)
With the banding removed, lower the tongue of the PRO down towards the ground. The PRO
may shift in the process, so be sure to keep feet clear of any possible pinch points while
lowering the tongue of the PRO.
6)
Connect the top link to the tongue of the PRO using the
hitch pin securing the square jack to the tongue of the
PRO. The top link will need to be adjusted to secure it back
to the upright mast ears on the back of the PRO. To adjust
the top link, hold the open end in one hand and spin the
top link out using the center bar in the top link. Once, the
top link is extended long enough to secure into the ears on
the upright mats, use the provided hitch pin and lynch pin
to secure it in place.
7)
The PRO is now ready to be attached to a tow vehicle. ABI recommends using a tow vehicle to
finish removing the PRO from the pallet. If a tow vehicle is not available at the time of assembly
please refrain from removing the PRO from the pallet until one is available. See section –
“Attaching the PRO to a Tow Vehicle” found on page 4 of this document for assistance on
connecting the PRO to a tow vehicle.
Figure 1
Figure 2
