How do I install the LiftMeUp to elevate my feet?
No assembly or tool required!
3 easy steps:
1- Position the LiftMeUp recliner on the mattress of your bed - with the handle bar about half
way between your hips and your knees when laying down - with the wooden slats facing up.
The LiftMeUp recliner can be installed on either side of a queen or king size bed. Make sure
that the whole width of the base and the handle bar are entirely in contact with the mattress.
Check that the wires are not pinched under the base or constricted in any way. Use the safety
strap to securely fasten the base of the LiftMeUp to the bed mattress. When the backrest
gets raised, the recliner will slip if not properly secured.
2- Cover the foam topper with the fitted sheet and position it on the backrest with its thicker
side aligned with the top of the frame.
3- Plug the cable into the wall plug. Make sure the wire is out of the way and does not
constitute a tripping hazard. On the hand control, press the 'UP' button for about 5 seconds
to raise the backrest then let go. This is to test that all connections are working properly. This
also allows you to stretch the fitted sheet over the back plate of the backrest to secure the
mattress in place. Use the hook to position the handset at a place easy to reach by the user.
Your LiftMeUp is now ready to use!
You may decide to use a thinner pillow than usual to avoid any interference with the operation
of the LiftMeUp recliner.
For detailed steps and pictures, please refer to the User’s Manual by using the link provided at
the bottom of the Page “Our Products” on our website.
How do I operate the LiftMeUp?
Once properly installed, your LiftMeUp is very easy to operate using the hand control:
• Raise the backrest by activating the
↑
button on the hand control. As soon as you let go, the
backrest stops in that position and remains there until one of the buttons is activated again.
• Push the
↓
button on the hand control to lower the backrest to any comfortable position or all
the way down.
What is the best position to lie on the LiftMeUp?
The optimal user position is to lie on the foam topper with your hips at the same level as the
handle bar.
Tall users should position themselves to have the top of their head lined up with the top of the
backrest. Make sure there is no risk of hitting the headboard or wall. You may want to use a
smaller size pillow to optimize your position.
How do I use the LiftMeUp to help me get in bed?
Raise the backrest to its maximum position (vertical). Sit in the middle of the foam topper and as
close as possible to the backrest and lean on it. Press the
↓
button continuously to lower the
backrest and progressively start moving your legs up to bring them on the bed while rotating
your torso, until you are lying comfortably on your back.
