Abell Adrenaline 3D V2, Manual

Page: 12 / 19

Next is plotting the position of the aileron servos. First you will need to make a mark on the
bottom of the wing 2 ½” away from the fuselage just behind the wings spar. Place a square on
the bottom of the wing so that one edge lines up with the aileron hinge line and the other edge
lines up with the mark on the bottom of the wing. Using the edge of the square as your guide,
draw a 1” line starting from the mark and stopping 1” behind the wing spar. Repeat for other
side. (Hint; if you don’t have a square you can use a sheet of printer paper or even a magazine)
Lightly sand one side of one of the aileron servos with sand paper then lightly sand the opposite
side of the second servo. Hot glue is used to attach the servos to the wing,
do not apply the hot
glue directly on the foam. Apply the hot glue to the sanded side of the servos and then place the
servo into position on the wing using the 1” line as a guide for the bottom edge of the servo and
the wing spar as a guide for the front of the servo as shown below. Repeat for other side.