abc ABC-MEMS, User Manual, Page: 24 / 43

User’s Manual 23
2. Make sure that the charge LED lights-up yellow or green, and that the operation LED starts
blinking. If not, review the installation procedure, or see section Troubleshooting.
3. Go to Start\All-Programs\ ABC _Instruments\Instrument_Manager , and run
Instrument_Manager.exe .
4. The front-panel described in Figure 9 appears, and the application tries to connect to the
instrument. If it fails to find the instrument it indicates No Device Found . If this is the case see
section Troubleshooting
5. Otherwise the application immediately starts communicating with the ABC Mems .
8.2 Main Functions
The application has five main tabs:
•
The Setup Tab: Is used to setup the instrument and monitor real-time signal (see
Figure 9 ).
•
The Records Tab: Is used to download, display and export the data from the meter
(see Figure 10 ).
•
The Spectrum Tab: Is used to display a real-time power spectrum from the meter
(see Figure 11 ).
•
The Static Tab: Is used to display static acceleration, inclination, and to check
calibration against the acceleration of gravity (see Figure 12 ).
•
The WiFi Tab: Is used to display the present connection state of the meter
and to setup its connection parameters (SSID, Security, Password…etc.) (see Figure 13 ).
8.3 Setup Tab
The setup tab is seen in Figure 9 . It is divided into seven fields.
8.3.1 Time and Date Field
This field displays the internal time of the instrument. If the instrument time is not properly adjusted,
press
Synchronize . This synchronizes precisely the instrument time to the PC time. Make sure the PC
time is accurate before synchronizing the instrument.
This field is also used to finely adjust the precision of the internal clock, if necessary.
Note: Time synchronization is not allowed while the instrument is recording.
8.3.2 Temperature Field
This field is used to display the instrument’s internal temperature in ° C or ° F. It is normal for the internal
temperature to rise slightly while the instrument is charging.
8.3.3 Instrument Info Field
The instrument info field provides instrument information, such as instrument model, serial number and
firmware revision. In addition the
User-ID field may be used to assign a custom identifier to the
instrument.