Abbra Home Control, Quick Start Manual

Page: 5 / 19

Insert the rechargeable battery pack.
Plug into the socket on the right hand
side of the compartment. Replace the
battery cover.
The backup batteries will need to charge
for 24 hours before they are fully
functional.
Please
do not attach the telephone cord
at this time. This will happen at the end of
Step 6.
Step 3
– Installing the
Wireless Sensors
There are two types of sensors included
in this kit. The magnetic contact protects
doors or windows, and the movement
sensor tracks movement inside a room.
Important: Before you start, write down
the zone number of each sensor (labeled
on the back of the sensor), and where
you will place it. You will need these zone
numbers in order to program the Abbra
later.
Installing the Magnetic Contact
Activate the battery by removing the
transmitter cover, using a screwdriver.
Remove the red tag from the battery and
check that the LED flashes.
Replace the cover and tighten the screw.
Attach the the magnet to a door or
window, and the transmitter to the frame,
ensuring that the ^ mark on the
transmitter faces the magnet, and that
the two parts are no more than 1/4 inch
(0.25'') apart when the door or window is
closed.
The
Magnetic Contact is pre-
programmed with the name FRONT
DOOR and it has an ENTRY DELAY.
This means that if the door is opened
while the Abbra is on, you will have 45
seconds to switch it off before the siren
sounds. You can change these settings
later if you desire. This is particularly
recommended if you wish to use the
magnetic contact to protect a window.
Quick and easy press and stick
mount: You can install the Magnetic
Contact using the included adhesive
pads, or by screwing the transmitter and
magnet to the door and frame. Note that
the adhesive tape is very strong. The
bond will strengthen over time and set
completely after 72 hours. To attach with
screws, you must open the Magnetic
Contact and gently lever out the
circuit board. Use the casing to mark the
drill holes. Insert the wall plugs and screw
the case to the wall.
Replace the circuit board and transmitter
cover. If you have an uneven surface
which prevents the transmitter and the
magnet from aligning correctly, e.g. PVC
doors or windows, you may wish to use
the spacers provided. Please refer to the
main User Guide for more information.