Do not instal within 10 feet of a pool, spa or fountain
CAUTION:
fixture(s) must be installed in accordance with all local codes and ordinances.
INSTALLATION INSTRUCTION
www.ABBALightingUSA.com
To ensure optimal performance and safety, it is
important to use our fixtures ONLY with a low
voltage
landscape
transformer.
This
transformer reduces the voltage from 120V to
12V, making it safe and suitable for outdoor use.
When installing the fixture(s), please follow
these instructions carefully:
1.Before installation, please ensure that
the power is turned off for your safety.
2.To properly install the Step light, you will need
to carefully punch hole on the deck that match
the size of the JUCTION BOX and the screws. To
do this, use a drill bit or hole saw that is the
same diameter as the JUNCTION BOX and for
the screws. Make sure to measure and mark the
hole accurately beforehand. Once the hole are
made, you can proceed to install.
3. Attach the wires from the fixture(s) to the
main cable, For best results, we recommend
using
WN12
waterproof wire nuts (which are
sold separately) to ensure optimal connectivity
and protection against dust, moisture and water
damage. Simply thread the wires through the
wire nut and twist it until it is securely in place.
5. Align the wires: Hold the stripped ends of the
two wires together, aligning them neatly and
ensuring that no stray strands are crossing over.
4.Strip
the
insulation:
Carefully
strip
approximately 3/4 inch (1.9 cm) of insulation
from the ends of the two wires you wish to
connect. Ensure that the bare metal ends are
clean and free from any frayed strands.
6. Insert the aligned ends of the wires into the wire
nut, ensuring that they go all the way in. The bare
ends should be completely covered by the wire
nut. Twist the wire nut: Firmly twist the wire nut
clockwise onto the wires, ensuring a secure
connection. Continue twisting until the wire nut is
tight and snug. For added safety, it is
recommended to apply electrical tape around the
wire nuts and wires as an extra layer of protection.
Confirm that the metal plate is firmly and
evenly attached to the wall, without any
wobbling or misalignment.
Use a level to verify that the metal plate is
horizontally or vertically aligned, as desired.
7.Place the metal plate against the wall, aligning
the screw holes with the pilot holes you created.
8.Take the screws and insert them through the
holes in the metal plate, one at a time. For deck
installation, position the metal plate carefully
within the hole.
9.Using a screwdriver, tighten the screws gradually
and evenly, ensuring a secure attachment of the
metal plate to the wall. Be cautious not to
overtighten and damage the wall surface.
10.Remember to test the fixture after making any
adjustments to ensure it is functioning correctly
and that the lighting is set to your preferences.
11.Once the fixture(s) have been installed
securely, it's time to turn on the power and enjoy
the enhanced lighting experience! Locate the
power switch or breaker that controls the
fixture(s) and turn it on. Take a moment to observe
the lighting effect
Remember to regularly maintain and clean the
fixture(s) to ensure optimal performance and
longevity.
