ABB XAC18723, Operation Manual

Page: 43 / 136

Operation Manual / 4 Product description / A100-L
3 Commissioning / 3.3 Commissioning after taking out of operation
© Copyright 2018 ABB. All rights reserved. HZTL4034_EN Revision M August 2018
3.2.4 Checks when starting up the engine
u Measure speed, oil pressure and charging pressure at various engine performances.
u
Measure the exhaust gas temperature before and after the turbine.
u
Measure the air temperature before and after the compressor.
u
Compare the measured values with the values of the acceptance report. Different operat-
ing conditions indicate a malfunction (see Chapter
Troubleshooting → 44 ).
Escape of oily fluids
Lubricants and pastes used during assembly can liquefy or vaporise and escape as oily fluids
during the initial hours of operation. Continual escape of an oily fluid indicates an oil leak.
u
If there is a leak, contact an ABB Turbocharging Service Station.
3.3 Commissioning after taking out of operation
If present
u
Remove cover plates (blind flanges) from the compressor casing, the gas inlet and the
gas outlet.
General
u
Check the exhaust gas pipe before and after the turbine for combustion residues or wa-
ter residues and clean it. Remove any foreign objects that may be present.
u
Check and clean filter silencer or air supply line, and remove any foreign objects that may
be present.
u
Put engine-side oil circulation to the turbocharger into operation.
u
Prepare the turbocharger for operation (see Checks before commissioning → 14 ).
u
The turbocharger is now ready for operation.
Page
15
/
108