ABB-Welcome
Mounting / Installation
| CKA001473B7516
— 34 —
4 Set the address of the preferred outdoor stations and the address of the indoor station on the rotary switches
(see chapter "Addressing" on page 36).
Fig. 27:
5. Set the master/slave function and the terminal resistor on the switches at the rear of the top part of the
housing (see chapter "Setting the master/slave switch" on page 29).
Fig. 28:
6.
Latch the upper part of the device onto its bottom part. To do this, place the upper side of the device on
the lock-in lugs and then press the bottom side onto the bottom part of the device until the clamp catches.
The installation of the indoor station is now complete.
1 2
ON
0
1
3
1 2
ON
M/S
RC
