![ABB TPS 50B01 Operation Manual Download Page 17](http://html2.mh-extra.com/html/abb/tps-50b01/tps-50b01_operation-manual_5245641017.webp)
Operation Manual / TPS50
2 Safety / 2.4 Safe operation and maintenance
© Copyright 2021 . All rights reserved.
HZTL2401_EN
Rev.A
September 2021
u
Keep the workplace clean, clear away loose objects and remove
obstacles on the floor.
u
Keep the floor, equipment and the turbocharger clean.
u
Have oil binding materials ready at hand and keep oil catch pans
ready or in position
u
Eliminate leaks.
u
Keep fire-protection materials and fire-extinguishing equipment
ready.
Welding work close to the turbocharger
u
If welding work is being carried out in the vicinity of the turbocharger,
cover the filter silencer so that the filter mat is not damaged.
u
Remove combustible objects and substances out of the range of fly-
ing sparks.
u
Cover all connections on the turbocharger so that no foreign objects
can get into the turbocharger.
u
Wear personal protective equipment (PPE) for welding operations.
Safety during start-up / commissioning and operation
u
Before starting work, carry out visual inspection of working area.
u
Remove any obstacles and objects lying around.
u
Before start-up / commissioning, check all pipes from and to tur-
bocharger for damage and leaks.
u
Don't work in any way that could impair safety when working on tur-
bocharger.
u
After about every 12 hours of operation or at least once a day, inspect
turbocharger for visible damage and defects.
u
Immediately report any damage or changes in operational perform-
ance to person responsible.
u
If damage is discovered, immediately shut down turbocharger and se-
cure it against inadvertent or unauthorized use.
u
When switching on auxiliary power sources (hydraulics, pneumatics,
electricity, water), keep an eye open for any hazards resulting from
supplying these power sources.
Safety during cleaning
If cleaning agents or solvents are used for cleaning, the corresponding
material safety data sheet and the safety instructions in section "Haz-
ards due to operating and auxiliary materials" must be observed.
u
Observe the material safety data sheet for the cleaning agent or
solvent.
Page
15
/
71