37
SA FEG E A R® MOTOR CONTROL CE NTE R/A RC- R E S I STA NT M ETA L- CL A D CON STRUC TI ON
Bar
spacer
Bar
spacer
Bolts
—
07 Place bar spacers
where needed. Insert a
bolt in all four holes to
secure the bus bar. Do
not tighten any of the
bolts before you place the
main bus bar. Once the
main bus bar is placed
tighten the eight bolts.
If spacers are needed,
they are going to be
supplied by the factory.
—
08 This picture is for
reference only it may not
represent your actual
setup. Please refer to
the standard or special
drawing provided to you
by the project engineer
for guidelines. Use the
torque wrench to tighten
all ½” – 13 UNC bolts,
they must be tightened
to ABB specifications
- see Appendix D.
—
07
—
08
