For more details on wall mounting, refer to
Installation
manual
.
1
2
3
4
5
6
IEC17000054-1-en.vsdx
IEC17000054 V1 EN-US
Figure 5.
Wall mounting details
Side-by-side mounting
IP649-1 v1
M1970-3 v1
Use the side-by-side mounting kit to mount two IEDs or a
IED and its corresponding test switch module next to each
other.
M1965-3 v3
The side-by-side mounting kit consists of two mounting
plates with appropriate mounting details (1 and 2). The
side-by-side mounted units are mounted in a rack or cubicle
using the appropriate kit; in this example, the rack mounting
kit (3) is used.
IEC040004563enOriginal.vsdx
1
2
3
4
3
IEC04000456 V3 EN-US
Figure 6.
The side-by-side mounting kit
Protection cover for rear area
M10592-3 v1
The protection cover for the rear area is a steel cover with a
slot for cable entrance at the bottom part.
IEC05000503-3-en.vsdx
IEC05000503 V3 EN-US
Figure 7.
Protection cover for rear area
3. RHGS cases
RHGS Cases
SEMOD121089-4 v2
Color matched (RAL7035) RHGS cases can be used to
mount for example Combiflex modules together with 670
series. See section
more detailed information about dimensions. Please
observe that cases in referenced document has a different
color.
4. Test switch module
General
M1955-3 v4
The test switch module consists of a RHGS 6 case with a
test switch, RTXP 24, and a two-seat Combiflex terminal
base mounted. An optional DC-switch occupies one seat if
selected. A side-by-side mounting kit is included. The side-
by-side mounted units are mounted in a rack or cubicle
using the appropriate kit, for example the rack mounting kit.
All connections to the test switch module are made with
Combiflex socket leads. Test contacts 1-24 of the test
switch have 20 A Combiflex terminals. The signal contact of
the test switch and the Combiflex terminal base have 10 A
terminals.
For more details about the Combitest system and Combiflex
system see section
.
670/650 series and SAM600-IO IEC
1MRK 514 012-BEN K
8
Hitachi Power Grids
© 2017 - 2021 Hitachi Power Grids. All rights reserved.