ABB PVS800-57-0100kW-A, Hardware Manual, Page: 101 / 180

Start-up 99
8
Start-up
Contents of this chapter
This chapter describes the start-up procedure of the inverter. It also gives some advice for
operation.
Start-up procedure
The functioning of the inverter is first tested in the local control mode with the control panel
(CDP312R). Thereafter, the control program parameters are set. The start-up procedure is
described step-by-step in the table below.
SAFETY
WARNING! Obey the safety instructions during the
installation and start-up procedure. See chapter Safety
instructions .
Only qualified electricians are allowed to install and start-up the
inverter.
PRIMARY AND AMBIENT CONDITION CHECKS
Check that the mechanical and electrical installation of the
inverter is OK. See chapter
Installation checklist .
Check that the insulation of the assembly is OK. See section
Checking the insulation of the assembly , page 83 .
Note: If the insulation is not OK, the
optional insulation resistance
monitoring (Q954, +Q976 or
+Q981) cannot be tuned properly.
Check that the ambient conditions for start-up, temperature and
humidity level is within the limits. See section
Ambient conditions ,
page 144 .
Note: Depending on the humidity level or temperature, it can be
necessary to use cabinet heaters continuously for a longer time
before start-up.