Operation Manual / Power2 340-H / Low-pressure stage
4 Commissioning / 4.1 Oil supply
© Copyright 2022 ABB. All rights reserved.
HZTL4053_EN
Rev.F
March 2022
4
Commissioning
4.1
Oil supply
4.1.1
Introduction
In all operating states, a functioning and carefully executed oil supply is an important pre-
requisite for trouble-free operation of the low-pressure and high-pressure stage.
The low-pressure and high-pressure stage are usually lubricated with oil from the engine oil
circulation.
u
The directives of the enginebuilder on the selection of the lubricating oil and the oil
change intervals must be followed.
4.1.2
Pre-lubrication
Before the engine is started, the plain bearings of the low-pressure and high-pressure stage
must be pre-lubricated. You can do this by using an electrically driven oil pump.
u
Switch on the oil pump.
u
u
Do not exceed a pre-lubrication time of 2 minutes.
u
Start the engine.
u
Let the oil pump run until the pump driven by the engine generates sufficient pressure.
Turbo Systems recommends integrating the entire pre-lubrication cycle into the engine con-
trol.
4.1.3
Oil filtering
Lubricating oil filtering with a filter mesh width of ≤ 0.034 mm is sufficient for these low-
pressure and high-pressure stages.
4.1.4
Oil pressure
Comply precisely with the oil pressure before the low-pressure and high-pressure stage for
trouble-free operation.
The admissible values are specified in chapter
.
4.1.5
Oil orifice on the low-pressure and high-pressure stage
With an oil inlet pressure of more than 3 bar (when engine under load) before the low-pres-
sure or high-pressure stage, the bearing casings are equipped as standard with an orifice at
the oil inlet.
Page
36
/
122
Summary of Contents for PT003924
Page 2: ......