ABB PST105, Installation And Commissioning Manual

Page: 17 / 200

Quickstart
Chapter 2
17
1SFC132003M0201
Chapter 2 Quickstart
This chapter is a short guide to how to connect, do the
configuration and start the softstarter in the easiest way.
Warning!
Mounting, electrical connection and settings of the
softstarter shall be made in accordance with existing laws
and regulations and be performed by authorized personnel.
Do not change any parameters in the Service Settings
menu.
2:1 Connection
1. Mount the softstarter according to Chapter 4 “Mounting” .
2. Be aware of the ambient temperature.
Derating is required above 40
°
C (104
°
F).
3. Connect the main circuit: terminals 1L1 - 3L2 - 5L3 to the
line side and terminals 2T1 - 4T2 - 6T3 to the motor side.
4. Connect the supply voltage: terminal 1 and 2
(100-250V 50/60Hz).
5. Connect the functional ground: terminal 3.
The wire shall be as short as possible, and be connected to
the mounting plate. The mounting plate should also be
earthed.
6. Connect the start/stop circuits: terminal 4, 5, 8, 9, and 10
according to the diagram, with 24V DC.
Warning!
Terminal 4, 5, 6, 7, 8, 9, 10, and 11 should be connected
using
24V DC only
. Other voltages may damage the
softstarter and the warranty may no longer be valid.
7. Check that the main and supply voltage corresponds to
the softstarter ratings.
8. Switch on the supply voltage.
9. The green "Power on" LED is on and the LCD shall
appear as in Figure 3.
Power on Protection Fault
1
2
3
4
1SFC132029F0001
U= 0% I=0.0A
Menu
Figure 1:
1 Status indication LEDs
2 LCD display
3 Selection keys for selecting, changing
and storing parameters
4 Navigation keys for navigating in the
menus
Arrows shown in the display indicates
that the value/menu is possible to
change or scroll
L1
L2
L3
N
KM1
1L1 3L2 5L3
2T1 4T2 6T3 12 13 14 15 16 17 18 19 20
U V W
1 2 3 4 5 6 7 8 9 10
4 5 10
11
M
3
24 V DC
1SFC132030F0001
Figure 2: Standard connection PST
Start Stop
Start
Stop
Power on Protection Fault
Figure 3: Top level
U= 0% I=0.0A
Menu