Operation Manual / Power2 650-M / Low-pressure stage
4 Commissioning / 4.1 Oil supply
© Copyright 2022 ABB. All rights reserved.
HZTL4065_EN
Rev.E
March 2022
4
Commissioning
4.1
Oil supply
4.1.1
Introduction
In all operating states, a functioning and carefully executed oil supply is an important pre-
requisite for trouble-free operation of the low-pressure and high-pressure stage.
The low-pressure and high-pressure stage are usually lubricated with oil from the engine oil
circulation.
u
The directives of the enginebuilder on the selection of the lubricating oil and the oil
change intervals must be followed.
4.1.2
Pre-lubrication
Before the engine is started, the plain bearings of the low-pressure and high-pressure stage
must be pre-lubricated, in order to avoid bearing damage caused by dry running.
u
Adhere to the admissible oil pressure range&.
An electrically driven oil pump is recommended for pre-lubrication.
Power2
Pre-lubrication time
650
2 min
Table 9: Pre-lubrication time
4.1.3
Post-lubrication
Post-lubrication is necessary after switching the engine off, in order to avoid oil coking in
the vicinity of the shaft seal. The post-lubrication time starts as soon as the oil pressure
drops below the admissible value due to switching off the engine.
u
Adhere to the admissible oil pressure range
(see Table 12: Oil pressure range
.
An electrically driven oil pump is recommended for post-lubrication.
Power2
Post-lubrication time
650
30 min
Table 10: Post-lubrication time
Page
33
/
119