Page 3
© 2021 ABB. All rights reserved.
QUICK START GUIDE
ID Switch is on the left side near the rear.
•
Strip wire
3/16”
•
Insert wire fully into wire entry
•
Tighten screw
•
•
SW2
Alarm
•
•
•
Screw
(1/16”
flat screw
driver)
•
Verify Module Type
-
use only 150045202 (PS1200DCxx) modules.
•
Slide converter into its slot approximately 3/4 of the way.
•
•
Slide the unit into the slot until it engages with the back of the shelf.
Swing the faceplate closed to fully seat the converter. Verify the faceplate
is latched.
•
•
Turn on the DC input breakers.
•
Wait until LEDs stop blinking
-
up to 5 minutes.
•
