Page 13
© Copyright 2021 ABB. All rights reserved.
All load cables are to be routed through the wireway as shown in figure 3
-
6. Loads exit the AC
Distribution Panel via the rear access holes. Knockouts are provided for 1/2" or 3/4" conduit as
required. Panels with knockouts are removable to facilitate removal of knockouts.
3.4 LOAD CONNECTIONS (WITH OUTLETS)
Refer to paragraph 3
-
3 for systems without outlets. All internal connections to outlets from CB
distribution has been accomplished at the factory, except load wire. Load wire (black) from
the outlet will need to be connected to the load side of the circuit breaker when installed.
Installer is required to fabricate the plugs for the load connections using the recommended
wire size as identified in the chart below. See Figure 3
-
5.
Loads routed through
wireway as shown.
Figure 3
-
6: Load Wireway Top View
Circuit Breaker Rating
Terminal Capacity
Terminal Type
Recommended Wire Size
2
–
15
Amps per position
4
-
14 AWG
Compression
Dependant on load
Ground
Load
Neutral
Figure 3
-
7: Ground, Load, Neutral Connections (With Outlets)
