16 NETA-21 remote monitoring tool
PNL 1/
PNL 2
Off
No devices (no wire) connected to the PNL port
Green
All devices connected, identified and commissioned
Blinking green Manual or automatic discovery of devices in progress
Yellow
Communication OK, but device connectivity limited.
All devices are ready to be unplugged/disconnected.
Red
Communication error caused the panel port network
initialization to fail.
Unknown device in the network, or something is interfering the
network and preventing proper detection of monitored devices.
Blinking red
Unsupported device is found in the network, or there are too
many devices in the network to be monitored
PC ETH 1
Off
PC not connected.
If an Ethernet cable is connected to the PC ETH 1 port but no
one uses the tool, the LED remains blank.
Green
Connection set up and in operation, for example, DHCP is
active and at least one PC has got an IP-address
1/2-second
blinking green
DHCP server is active.
NETA-21 provides IP addresses for local devices.
1-second
blinking green
At least one user has been logged on to the user interface
Blinking yellow Factory-level access/operation.
Firmware update in progress.
Note:
System status (STAT LED) blinks during the firmware
update.
PWR
Off
Power off
Green
Power on
Yellow
Timed power off or standby.
NETA-21 can go to the standby mode as a protective measure
(eg, if the environmental temperature is too high).
To wake up the NETA-21, press the SD RJ45 button.
Name
Color
Function
Summary of Contents for NETA-21
Page 2: ......
