32
M ICROG UA R D™ SOLUTION |
M I C R O G UA R D | U M/M I C R O G UA R D - EN R E V. B
6 Using the System
Hardware Inspection
Inspect all pieces for damage and ensure the functional quality
of the items below:
Analyzer:
• No loose wires .
– Nothing loose in the pelican case .
– Batteries are charging and operating normally .
– Analyzer turns on normally .
– Analyzer pump is on .
– Suction at the tip of the analyzer inlet .
IMPORTANT!
To prevent damage to the inlet tip, do not hit the tip against
anything during emission investigations . If the tip happens
to fall out,
carefully insert the end of the tip back into the
tubing .
• NX6: powers on and charges as normal .
• Inlet tubing:
– Intact, not bent .
– Secures into the analyzer inlet port as normal .
– Secures in the handle as normal .
– Filter tip is not bent or damaged .
• Handle:
– All pieces intact .
– Device frame holds the device .
– Nothing is bent or out of place .
– The screw for the wand operates normally .
System Power-On
1
Power on the Android device .
2
Turn on the analyzer . Refer to GLA131 Series Microportable
user manual, document #3KXG167001R4601 .
Software Startup
To start up the MicroGuard™ application, the analyzer
and phablet must already be turned on . Then, perform the
following:
NOTE
If at any time during use of MicroGuard™ you are prompted
with messages similar to the following example, select the
option to
Cancel/Deny/Don’t Send .
Figure 78 Cancel Message
Figure 79 Purchase Agreement Terms and Conditions
1
Open the MicroGuard™ application .
2
Accept the terms and conditions of the purchase agreement .
3
Log into the application: Enter your username and password .
The default password is the same as the username .
There are two usernames:
admin and tech .
NOTE
If five attempts are made at inputting an incorrect
password, you will be locked out for one hour before
another attempt can be made .
