6
OI/LMS100-EN Rev. A |
LMS100 Magnetic Level Gauge Switch
5.2 Requirements for Hazardous Locations
5.2.1 General Guidelines
1. WARNING!
MAKE SURE ALL CIRCUITS ARE DE-ENER-
GIZED PRIOR TO INSTALLATION.
2. The LMS100 has been evaluated as an Installation
(Overvoltage) Category 1 / Pollution Degree 2 apparatus
per IEC 1010.
3. The maximum altitude of operation is 6560 feet (2000
meters).
4. The LMS100 is designed with both internal and external
protective earth (ground) terminals.
5. Housing and cover are made from 316L SS. Assess
material suitability for the target environment
before deploying.
6. Additional flamepath information available upon request.
7. Product label may be susceptible to electrostatic charge
buildup in Group III environments. Care should be taken
to prevent the buildup of electrostatic charge. Clean
only with a damp cloth
8. Do not torque any attached conduits, thread adapters,
reducers, elbows, or cable glands beyond the manu-
facturer’s recommended installation torque. Torque
requirements for the LMS100’s optional thread adapters
are listed below.
Option
Description
Recommended
Torque
U8
M20 adapter 316 SS
32.5 Nm
E8
1/2 inch by 1/2 inch
NPT elbow
35 Nm
E9
1/2 inch NPT by M20
elbow
35 Nm
5.2.2 Nameplate Marking Procedure (Declaration of Protec-
tion Concept)
Before installing the switch, permanently indicate the protec-
tion concept associated with the hazardous area by marking the
corresponding box on the product label. Only one box shall be
marked. The chosen protection concept cannot be altered and
shall govern the use of the product until end of life. If more than
one protection concept is marked, the switch must be removed
from the hazardous area immediately.
FM/FM-C Name Plate
1
2
3
4
A
B
C
D
1
2
3
4
A
B
C
D
The information contained herein is
proprietary to and considered a trade
secret of ABB Inc., and shall not be
reproduced, in whole or
in part, without the written authorization
of ABB Inc.
Lang.:
Prepared by:
Title:
Part No.:
Doc. Type:
Date:
Rev.:
Sheet:
Drawing No.:
Approved by:
PA/MP/LM
Resp.
K-TEK PRODUCTS
18321 SWAMP ROAD
PRAIRIEVILLE, LA. 70769 USA
EN
LMS100 FM/FM-C
NAMEPLATE
Norman W Guidry
Eric Fauveau
08/05/14
3KXL000391U0200
3KXL000391U0209
-
ARTWORK DRAWING
1 of 1
REV
DESCRIPTION
APPROVED
DATE
-
ECN0915
E.F.
-
CRITICAL / SCHEDULE DOCUMENT
NO MODIFICATION PERMITTED WITHOUT APPROVAL
FROM AGENCY / NOTIFIED BODY
NOTES:
1. LABEL MATERIAL:
- SUBSTRATE LAYER: BRADY B-428
- OVERLAMINATE LAYER: BRADY B-111
- ADHESIVE LAYERS: HIGH PERFORMANCE ACRYLIC
2. LABEL TEMP. RANGE: -40°C TO 150°C (OUTDOOR)
3. LABEL MUST BE RESISTANT TO OCCASIONAL EXPOSURE TO
PETROLEUM SOLVENTS.
4. REFER TO 3KXL000391U0018 FOR MARKING PROCEDURE.
5. DIMENSIONS ARE IN INCHES [MM].
SUBSTRATE LAYER
ADHESIVE LAYER
ADHESIVE LAYER
OVERLAMINATE LAYER
3KXL000391U0200 LAYERS
3KXL000460U0100
3KXL000461U0100
PRO
DE
3KXl
!
L
4.000
.700
K-TEK PRODUCTS
250V MAX
1A MAX
60VA MAX
(NON-IS/NI)
TYPE 4X; NO ACIDIC ATMOSPHERES / AUCUN ATMOSPHERES ACIDES; IS / NI
PER CONTROL DWG 3KXL130100G0022; CONDUIT SEAL REQUIRED WITHIN
2 IN / SCELLEMENT EXIGE SUR CONDUIT A 50 MM; -40°C
≤
T
A
≤
70°C
CLII DIV2 GP EFG T6; CLIII T6
CLI Zn2 AEx nC IIC T6...T1
Ex nC IIC T6...T1 Gc
NI: CLI DIV2 GP ABCD T6
CLII GP EFG T6; CLIII T6
CLI Zn1 AEx d IIC T6...T1
Ex d IIC T6...T1 Gb
Zn21 AEx tb IIIC T85°C...T450°C
XP: CLI GP ABCD T6
CLII GP EFG T6; CLIII T6
CLI Zn0 AEx ia IIC T6...T1
Ex ia IIC T6...T1 Ga
Zn20 AEx ia IIIC T85°C...T450°C
IS: CLI GP ABCD T6
FM
APPROVED
C
US
MADE IN USA
LMS100.XX.XX.XX.XX
SN: 3K650000000000
MAGNETIC SWITCH
SEE MANUAL
OI/LMS100
!
!
K-TEK PRODUCTS
250V MAX
1A MAX
60VA MAX
(NON-IS/NI)
TYPE 4X; NO ACIDIC ATMOSPHERES / AUCUN ATMOSPHERES ACIDES; IS / NI
PER CONTROL DWG 3KXL130100G0022; CONDUIT SEAL REQUIRED WITHIN
2 IN / SCELLEMENT EXIGE SUR CONDUIT A 50 MM; -40°C
≤
T
A
≤
70°C
CLII DIV2 GP EFG T6; CLIII T6
CLI Zn2 AEx nC IIC T6...T1
Ex nC IIC T6...T1 Gc
NI: CLI DIV2 GP ABCD T6
CLII GP EFG T6; CLIII T6
CLI Zn1 AEx d IIC T6...T1
Ex d IIC T6...T1 Gb
Zn21 AEx tb IIIC T85°C...T450°C
XP: CLI GP ABCD T6
CLII GP EFG T6; CLIII T6
CLI Zn0 AEx ia IIC T6...T1
Ex ia IIC T6...T1 Ga
Zn20 AEx ia IIIC T85°C...T450°C
IS: CLI GP ABCD T6
FM
APPROVED
C
US
MADE IN USA
LMS100.XX.XX.XX.XX
SN: 3K650000000000
MAGNETIC SWITCH
SEE MANUAL
OI/LMS100
!
!
ATEX/IECEx Name Plate
1
2
3
4
A
B
C
D
1
2
3
4
A
B
C
D
The information contained herein is
proprietary to and considered a trade
secret of ABB Inc., and shall not be
reproduced, in whole or
in part, without the written authorization
of ABB Inc.
Lang.:
Prepared by:
Title:
Part No.:
Doc. Type:
Date:
Rev.:
Sheet:
Drawing No.:
Approved by:
PA/MP/LM
Resp.
K-TEK PRODUCTS
18321 SWAMP ROAD
PRAIRIEVILLE, LA. 70769 USA
EN
LMS100 ATEX/IECEx
NAMEPLATE DRAWING
Norman W Guidry
Eric Fauveau
08/05/14
3KXL000391U0100 3KXL000391U0109
-
ARTWORK DRAWING
1 of 1
REV
DESCRIPTION
APPROVED
DATE
-
ECN0915
E.F.
-
CRITICAL / SCHEDULE DOCUMENT
NO MODIFICATION PERMITTED WITHOUT APPROVAL
FROM AGENCY / NOTIFIED BODY
.700 [17.8]
4.00 [101.6]
SUBSTRATE LAYER
ADHESIVE LAYER
ADHESIVE LAYER
OVERLAMINATE LAYER
3KXL000391U0100 LAYERS
3KXL000460U0100
3KXL000461U0100
PRO
DE
3KXl
!
L
NOTES:
1. LABEL MATERIAL:
- SUBSTRATE LAYER: BRADY B-428
- OVERLAMINATE LAYER: BRADY B-111
- ADHESIVE LAYERS: HIGH PERFORMANCE ACRYLIC
2. LABEL TEMP. RANGE: -40°C TO 150°C (OUTDOOR)
3. LABEL MUST BE RESISTANT TO OCCASIONAL EXPOSURE TO
PETROLEUM SOLVENTS.
4. REFER TO 3KXL000391U0018 FOR MARKING PROCEDURE.
5. DIMENSIONS ARE IN INCHES [MM].
MADE IN USA
IP66/IP67
-40°C
≤
T
A
≤
70°C
II 2 G, Ex d IIC T6...T1 Gb
II 2 D, Ex tb IIIC T85°C...T450°C Db
FM14ATEX0029X, IECEx FMG 14.0015X
II 1 G, Ex ia IIC T6...T1 Ga
II 1 D, Ex ia IIIC T85°C...T450°C Da
FM14ATEX0030X, IECEx FMG 14.0015X
II 3 G, Ex nC IIC T6...T1 Gc
FM14ATEX0031X, IECEx FMG 14.0015X
SEE MANUAL
OI/LMS100
!
!
LMS100.XX.XX.XX.XX
SN: 3K650000000000
MAGNETIC SWITCH
0575
250V MAX
1A MAX
60VA MAX
(NON-IS/NI)
K-TEK PRODUCTS
MADE IN USA
IP66/IP67
-40°C
≤
T
A
≤
70°C
II 2 G, Ex d IIC T6...T1 Gb
II 2 D, Ex tb IIIC T85°C...T450°C Db
FM14ATEX0029X, IECEx FMG 14.0015X
II 1 G, Ex ia IIC T6...T1 Ga
II 1 D, Ex ia IIIC T85°C...T450°C Da
FM14ATEX0030X, IECEx FMG 14.0015X
II 3 G, Ex nC IIC T6...T1 Gc
FM14ATEX0031X, IECEx FMG 14.0015X
SEE MANUAL
OI/LMS100
!
!
LMS100.XX.XX.XX.XX
SN: 3K650000000000
MAGNETIC SWITCH
0575
250V MAX
1A MAX
60VA MAX
(NON-IS/NI)
K-TEK PRODUCTS
