2024-01-24
4/4
—
FUNCTIONALITY
In normal condition, with insulation value higher than the set threshold, the instrument has the green LED on.
Pressing the TEST button, the TRIP LED of alarm signalling and the output relay will be activated.
Depending on the connection, the RESET will be automatic when the TEST button is released, or using a re-
mote button, or manually using the RESET button on the front panel.
If there is low insulation on the line (resistance value under the set threshold), the TRIP signalling and the out-
put relay will be activated.
When the insulation on the line comes back higher than the set threshold, the trip signalling will disappear.
—
TECHNICAL FEATURES
Auxiliary voltage supply
230V 50-60Hz ± 20% or 110V 50-60Hz ± 20%
Maximum consumption
3 VA
Network to control
24 ÷ 10% (760V on three-phase line with neutral)
Measure voltage
Max 24V
Measure current
Max 0,5 mA
Internal impedance
100
kΩ
Threshold tripping
Settable 10 ÷ 150
kΩ
(4 level with micro-switches)
Tripping delay
About 1 second
Signalling and button
Led ON, led TRIP; TEST and RESET button
Output
Relay changeover contact NA-C-NC max 5A 250Vca
Working and storing temperature
-10 ÷ 60°C / -20 ÷ 70°C
Relative humidity
≤ 95 %
Insulation test
3 kV 60 sec. / 4 kV imp.
1,2/50μs
Mounting position
Any
Wiring type
Screw terminals / cross section cables 4 mm²
Protection degree
Front with cover: IP 40
–
Enclosure: IP 20
Mounting according DIN 50022
Snap on DIN rail 35mm / 3 modules 17,5 mm
Weight
About 300 g
Standards
Safety IEC-EN 61010-1
Product IEC-EN 61557-8
Electromagnetic compatibility IEC-EN 61326-1
For application not described in this manual it’s better to see specific document or to contact the technical
service.
—
NOTE
At reason of the evolution of standards and products, the company reserves to modify in every time the features of the product described
in this document, that it’s
necessary to verify preventively.
The liability of the producer for damage caused by defect of the product ”can
be reduced or deleted (…) when the damage is caused joint by a defect of product or
for blame of the damaged or a person of which the
damaged is responsible” (Article 8, 85/374/CEE).
1
