ABB i-bus
®
KNX
Parameters
32 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page
7.2.1.3
In Operation
This parameter is used to enable the Group Object
In Operation
. Readiness can be monitored by another
KNX device using this Group Object. If a telegram is not received, the sending device could be faulty or
the bus cable to the transmitting device could be interrupted.
Option
No
The function is deactivated.
Yes
The following dependent parameters are shown:
•
Sending cycle
Prerequisites for visibility
•
This parameter is in the
General
parameter window.
7.2.1.4
Sending cycle
This parameter is used to define the cycle in which the
In Operation
Group Object sends a telegram.
Option
1 … 5 … 255 min
Prerequisites for visibility
•
Parameter window
General
\ parameter
In Operation
\ Option
Yes
.
•
This parameter is in the
General
parameter window.
