Main menu
4
Main menu
42/18-75 EN
4
Main menu
After power-on, the communicator performs a self-test. Then the communication to the
connected TZID-C/TZID-C200 is set up automatically, and the Online Menu seen below
is displayed:
The Online Menu provides five menu options:
•
Serve/ Watch
for display of several operating parameters
•
Settings
for setting the TZID-C/TZID-C200 parameters
•
Diagnostics
at present only providing an option for resetting the stroke and travel counters
•
Simulation
for simulating situations
•
Information
for entering/displaying device information
There are two ways to select a menu. You can either enter the number of the menu item
via the alphanumeric keypad or mark the option with the
key and then select it with the
key.
Pressing the
or
(HOME) key will return you to the main menu.
If the TZID-C/TZID-C200, with which you try to communicate via the HART
®
communi-
cator has already been set locally to the Conf mode, the following message will pop up:
"Local configuration is active occurred reading ... value. Press OK."
In this case it is not possible to configure the positioner via the communicator. If you
should ignore the message and nevertheless try to transmit data, the following message
is shown:
"Access restricted".
If you try to read parameters from the TZID-C/TZID-C200 which are currently being
modified locally, the input values are shown, even if they have not yet been confirmed
and stored in the TZID-C/TZID-C200 EEPROM. It is recommended to cancel communi-
cation from the communicator and retry at a later time.
TZID-C: -/-
Online
1 ->
2
3
4
5
Serve/Watch
Settings
Diagnostics
Simulation
Information
F3
