ABB FMBT-21, User Manual

Page: 25 / 92

Modbus/TCP – Start-up
Contents of this chapter
This chapter contains:
• information on configuring the drive for operation with the adapter module
• drive-specific instructions on starting up the drive with the adapter module
• information on configuring the client for communication with the adapter module.
Warnings
WARNING!
Obey the safety instructions given in this manual and the drive documentation.
Drive configuration
The information in this section applies to all drive types compatible with the adapter
module, unless otherwise stated.
￭
Modbus/TCP connection configuration
After the adapter module has been mechanically and electrically installed according
to the instructions in chapters
Mechanical installation and Electrical installation , you
must prepare the drive for communication with the module.
The detailed procedure of activating the module for Modbus/TCP communication
with the drive depends on the drive type. Normally, you must adjust a parameter to
activate the communication. See the drive-specific start-up sections.
Once communication between the drive and the adapter module is established, several
configuration parameters are copied to the drive. These parameters are shown in the
6
Modbus/TCP – Start-up 25
12