1.3.3 First test run may cause injury or damage
Description
After installation and performing service activities, there are several safety risks
to take into consideration before the first test run.
Safe handling
Use this procedure when performing the first test run after installation, maintenance,
or repair.
DANGER
Running the Product without fulfilling the following aspects, may involve a risk
of injury and cause severe damage to the Product.
Action
Remove all tools and foreign objects from the Product and its working area.
1
Verify that the Product is properly secured to its position by all screws, before it is
powered up.
2
Verify that any safety equipment installed to secure the position or restrict the Product
motion during service activity is removed.
3
Verify that the fixture and work piece are well secured, if applicable.
4
Install all safety equipment properly.
5
Make sure all personnel are standing at a safe distance from the Product, and is out
of its reach behind safety fences, or similar.
6
Verify that all required covers or paddings are properly secured to the Product, if any.
7
If maintenance or repair has been done, pay special attention to the function of the
part that was serviced.
8
Collision risks
CAUTION
When programming the movements of the Product, always identify potential
collision risks before the first test run.
Product manual - Feather Duster V2
21
3HAX010000210 Revision: A
© Copyright 2018 ABB. All rights reserved.
1 Safety
1.3.3 First test run may cause injury or damage
Summary of Contents for Feather Duster V2
