Tel: (888) 552-6467 Fax: (800) 316-4515
07/21 750.2158 Rev. B
3/16
EMIU 400W - 4 Option Mini Inverter
INSTALLATION
a. Remove the front cover of the Mini Inverter by removing the two screws at the top of the cover.
b. Extend the unswitched, properly-rated voltage AC supply and remote fixture wires to the installation area.
c. Orient cabinet to ensure clearance is 3.5 inches on either side of the Mini Inverter and 42 inches on the front. No clearance is
required on the bottom of the unit. For units equipped with optional wireless Nexus, a clearance of 6 inches is required on top to allow
for the protruding antenna. For units without wireless Nexus, no clearance is required on the top.
d. Use keyhole slots at the rear of the unit and mount the Mini Inverter securely to the wall.
e. Connect the conduit containing the AC supply and remote fixture leads to the Mini Inverter. Use the provided knock-outs on the side
of the Mini Inverter for connecting the incoming wires.
f. Install the batteries at this time, but do not connect the battery leads until other wiring is completed.
STEP 1: MOUNTING THE MINI INVERTER TO WALL (SEE FIGURE 1)
WARNING:
THE MINI INVERTER MUST BE MOUNTED SECURELY USING A 1/4” (MIN) SCREW AND FLAT WASHER
FOR EVERY KEYHOLE. THE MOUNTING SURFACE MUST ALSO BE SUFFICIENTLY REINFORCED TO
ACCOMODATE THE WEIGHT LISTED (SEE PAGE 1). FAILURE TO SECURE THE UNIT SUFFICIENTLY
CAN DAMAGE THE EQUIPMENT AND/OR CAUSE SERIOUS INJURY.
Unswitched input
TB1
FIGURE 1
Electronic
cabinet
Internal components
removed for clarity
of assembly.
Switched input
Output
CAUTION:
CABINET IS HEAVY AND AWKWARD TO LIFT. MAKE PROPER PROVISIONS TO ENSURE SAFETY OF
INSTALLERS.
Load voltage selector
