C1300
Advanced circular chart recorder
3 Configuration
IM/C1300 Rev. J
19
3 Configuration
3.1 Introduction
The configuration procedures are used to make changes to the operating parameter values and for scale adjustment. Configuration
of all channels is performed from faceplate 1.
The configuration settings can be backed up to a PC and restored to the recorder as required – see Section 3.16, page 58.
An overview of the
Configuration Pages
is on the rear cover fold-out.
When changing the input type, it may be necessary to reposition the input selector links accordingly – see Section 5.2.1, page 67.
3.2 Preparation for Configuration
3.3 Configuration Level Security
Unauthorized access to the configuration pages is prevented by the use of a security code.
The security code, set to '0' when the recorder is despatched, can be set to any value from 0 to 9999 – see
Configure Password
in
Section 3.4 on pgae 20. When set to anything other than '0', access to all configuration menus (i.e. all menus below
Security Code
)
is prevented. Enter the correct code to enable access to the configuration menus.
Note.
Isolate any external alarm/control circuits if inadvertent operation during configuration is undesirable.
The recorder responds instantly to parameter changes. These are saved automatically when either the
or
key is
pressed.
The display screen of faceplate 2 (if fitted) shows
Configuration Mode
when the configuration pages are accessed by
scrolling past
Security Code
in the Main Menu on the display screen of faceplate 1.
Security Code
Press the
key to open the
Main Menu
.
Highlight
Security Code
.
Enter Security Code
Enter the correct security code.
Return to Main Menu.
Enter Code
0000
Operating Level
Totalizer Log
Totalizer Control
Alarm Setpoints
Security Code
Common
Channels
Alarms
Operating Level
Totalizer Log
Totalizer Control
Alarm Setpoints
Security Code
Common
Channels
Alarms
